Analytic Systems PWS1000 Instrucciones de operaciones descargar pdf (Pagina 5)

General

Input Frequency 45 - 65 Hz

Noise on Input < 50 milli-Volts

Noise on Output < 50 milli-Volts

Transient Response < 1 V for 50% surge

Efciency > 80 % @ maximum output

Temp. Range -25 to +40 deg. C @ maximum output

Isolation

Input-Output & Input-Case 1500 Vdc

Output-Case 500 VDC (1500Vdc @ 48 V Out)

Isolation Output-Case 500VDC

Length 14.5 in / 36.8 cm

Width 10.2 in / 29.9 cm

Height 5.5 in / 14.0 cm

Clearance 1 Inch (2.5 cm) all around

Material Marine Grade Aluminum

Finish Anodized

Fastenings 18-8 Stainless

Weight 12 lb / 5.5 kg

Designed and manufactured by: ANALYTIC SYSTEMS WARE (1993) LTD.

8128 River Way

Delta, BC V4G 1K5 Canada

p. 604.946.9981 f. 604.946.9983

tf. 800.668.3884 US/Canada

www.analyticsystems.com [email protected] Revised January 2014

* Specications subjects to change without notice.

Installation

MOUNTING

Mount the unit in a DRY location. Allow at least 4 inches of clearance around the heat sink

ns for adequate cooling.

POWER CONNECTION

The unit is supplied with a 5 foot power cable. This should normally be adequate to connect to

a source of power. If you must extend the power cable be sure to use a 3 conductor grounded

type extension cable. For hard wiring to a source of power, cut off the plug, and strip the wires

as necessary. The wire colours are

110 VAC 220 VAC

Brown - AC Hot Brown - AC Hot / Phase 1

Blue - AC Neutral Blue - AC Neutral / Phase 2

Green - Ground Green/Yellow - Ground

1 2 3 4 5 6 7 8 9 10 11 12

Sin comentarios

Analytic Systems PWS1000 Instrucciones de operaciones Pagina 5